1/2 Size Steel Bridge For Telecaster (brass saddles only, no pickup housing) Option:Nickel Satin

1/2 Size Steel Bridge For Telecaster (brass saddles only, no pickup housing) Option:Nickel SatinMade in the USA, this Telecaster half bridge is specifically designed for Telecasters with vintage bridge specification requirements but cut down to allow for the installation of a humbucker or body mounting the original single coil instead of the full size plate. This superior quality bridge has a stamped steel baseplate with brass saddles and slotted height adjustment screws, just like the originals but with higher quality finish work and is

Humbucker baseplate in nickel silver with traditional L - shaped mounting tabs

Base Plate Material = fibre bottom

92mm)Height of bridge top piece = 33/64 in

As can be seen in the additional images

Superficial cracks and aging

Tune-O-Matic Bridge

and cannot be felt

Because these tuners have a larger string post the tuners do require the original larger peg hole which is very similar in size to what is used for modern die-cast tuners

Please note that this pickguard will only fit genuine 2010 to present 21 fret cutaway Fender Jazz Bass Deluxe

and the other at the bridge

000 turns or 7000 turns off 44 gauge wire by following the markings on the bottom of the pickup

All mounting hardware is included